Sanyo CD Player MCD XP630 User Guide

INSTRUCTION MANUAL  
CD Portable Radio  
MCD-XP630  
MCD-XP631  
PHONES  
LINE IN  
SANYO Electric Co., Ltd.  
Printed in China  
(AU)MR601P63000010  
 
4
10  
2
6
8
5
3
9
7
1
11  
12  
PHONES  
LINE IN  
13  
POWER SUPPLY  
AC Power  
Connect one end of the mains lead to the AC input socket (back of the unit) and the other  
end to an AC outlet.  
Note:  
-
The installed batteries are automatically disconnected when the mains lead is connected  
to the unit.  
-
The function switch is mounted on the secondary side. The unit is not disconnected from  
mains, even switched off.  
Battery power  
Installing batteries  
Install six “C/R14” batteries (not supplied).  
Caution on batteries  
To prevent battery electrolyte leakage, which may result in injury and damage to the unit  
or other objects, observe the following precautions:  
1. All batteries must be installed with the proper polarity (see diagram on the rear of the  
unit).  
2. Do not mix new with old or used batteries.  
3. Only use batteries of the same type and brand.  
4. Remove the batteries when they are not to be used for a long period time.  
5. When the batteries have become discharged, they must be disposed of in a safe manner  
which complies with all applicable laws.  
6. Battery shall not be exposed to excessive heat such as sunshine, re or the like.  
GENERAL OPERATION  
2
Adjusting the volume  
Turn the VOLUME control.  
 
2
Headphones  
Connect stereo headphones (not supplied) to the PHONES socket for monitoring or for  
private listening. The speakers are automatically disconnected when headphones are  
connected.  
-
Excessive sound pressure from earphones and headphones can cause hearing loss.  
5
1
CD PLAY  
1. Set the function switch to CD.  
2. Press the CD compartment lid (OPEN/CLOSE portion) to open it. “- -” appears on the  
display.  
3. Place the disc with the label facing up on the turntable. (Place only one disc at a time.)  
4. Press the CD compartment lid (OPEN / CLOSE portion) to close it.  
The total track number appears on the display.  
5. Press the ibutton. Play starts from the rst track.  
-
To start play from the desired track, select the track by using the f or e button,  
then press the ibutton.  
Note:  
If no disc is loaded or the disc is located with the label facing down, “- -” appears. If these  
occur, load the disc correctly or replace the damaged disc.  
6. Press the nbutton to end disc play back.  
When the last track has been played, the player stops automatically.  
7. To turn the CD player off, set the function switch to OFF.  
Note:  
-
-
-
Do not open the CD compartment during CD play. Always press the n button and wait  
for the disc to stop rotating before opening the CD compartment.  
This unit can play back the CD-R/RW as well. However, some CD-R/RW can not be  
played back depending on the recording conditions.  
This unit cannot playback MP3/WMA CD or Video CD.  
Notes on handling compact discs  
-
Do not expose the disc to direct sunlight, high humidity or high temperature for extended  
periods of time.  
-
-
-
-
Discs should be returned to their cases after use.  
Do not apply paper or write anything on the disc surface.  
Handle the disc by its edge. Do not touch the playing surface (glossy side).  
Fingerprints and dust should be carefully wiped off the playing surface of the disc with a  
soft cloth.  
Wipe in a straight motion from the center to the outside of the disc.  
Never use chemicals such as record cleaning sprays, antistatic sprays or uids, benzene  
or thinner to clean compact discs.  
-
5
Temporarily stopping play  
Press the ibutton, “a” blinks on the display. To resume play, press the button again.  
Skip play 4  
8
To skip to track 6 while track 3 is playing, press the ebutton repeatedly until “06” appears  
on the display. To skip back to track 3 while track 6 is playing, press the fbutton repeatedly  
until “03” appears.  
 
3
8
Search (forward/reverse) 4  
If the e or f button is pressed during play, the player will search at high speed in the  
forward or reverse direction while the button is being pressed. When the button is released,  
normal play will continue.  
9
Repeat/Random play  
Press the REPEAT/RANDOM button repeatedly to select the various play mode. Each time  
the button is pressed, the mode changes as shown below:  
“REPEAT ALL” appears  
(Repeat all tracks)  
“REPEAT” appears  
(Repeat one track)  
v
“RANDOM” appears  
(Play all tracks randomly)  
Released  
(Normal play)  
3
PROGRAMMED PLAY  
Up to 20 tracks on a disc can be programmed for play in any order.  
1. In stop mode press the MEMORY button, the program number “01” appears briey, then  
the track number “00” and “MEMORY” blink on the display.  
2. Select a track by using the for ebutton.  
3. Press the MEMORY button.  
4. Repeat steps 2 - 3 to programme additional tracks.  
5. Press the ibutton to start playback. “MEMORY” remains lit.  
When all programmed tracks have been played, the player stops automatically.  
-
The programme contents are retained in memory.  
To cancel the programmed play  
1. In stop mode press the MEMORY button. The programmed track number and “MEMORY”  
blink on the display.  
2. Press the nbutton once. The total track number of the disc appears.  
The programmed play is canceled.  
Checking the programme  
In stop mode press the MEMORY button repeatedly, the programme numbers and pro-  
grammed track numbers sequentially appear on the display.  
Changing a programme  
To add a new track to a programme:  
1. In stop mode press the MEMORY button repeatedly until the last program number is  
displayed briey, ‘‘00” appears.  
2. Select a track as explained above.  
3. Press the MEMORY button.  
To change a track:  
1. In stop mode press the MEMORY button repeatedly until the programme number to be  
replaced appears briey, then the track number blinks on the display.  
2. Select a track as explained above.  
3. Press the MEMORY button.  
 
4
Note:  
Programmed details cannot be partially deleted or inserted.  
WHAT TO DO IF...  
If an abnormal display indication or an operating problem occurs, disconnect the mains  
lead and remove all batteries. Wait at least 5 seconds then reconnect the mains lead and  
reinstall the batteries.Resume the operation.  
1
LISTENING TO OTHER SOURCES  
1. Connect the audio cable (not supplied) from the audio output socket of a video/auxiliary  
equipment to the LINE IN socket.(Stereo Mini Plug: ø3.5)  
2. Set the function switch to LINE IN.  
3. Follow the instructions supplied with the other equipment.  
11  
1
LISTENING TO THE RADIO  
1. Select FM or AM with the BAND switch.  
2. Tune in a desired station by turning the TUNING control.  
3. To turn the radio off, set the function switch to OFF.  
To improve reception  
FM: Pull out the telescopic aerial and adjust its position.  
AM: Rotate the unit.  
MAINTENANCE  
Cleaning the CD player lens  
The lens should never be touched. If dust is on the lens, blow it off using a camera lens  
blower. (Consult your dealer.)  
Cleaning the unit  
Clean the outside of the unit with a clean soft cloth, moistened with lukewarm water. Do  
not use benzene, thinners, or alcohol for they may mar the finish of the surfaces.  
SPECIFICATIONS  
CD player  
General  
Channels:  
Output power:  
2-Channel stereo  
Sampling frequency:  
44.1 KHz  
Pick-up:  
Semiconductor laser  
Laser output:  
1 W/ch (DC max.)  
1 W/ch (AC max.)  
Speakers:  
7.7 cm x 2, 8 ohms  
Terminals:  
PHONES: 32 ohms  
Power source:  
0.6 mW (Continuous wave max.)  
Wave length:  
AC: 230V - 240V, 50Hz  
790 nm  
DC: 9V, 6 “C/R14” batteries  
Wow/Flutter:  
Dimensions:  
282 (W) x 137 (H) x 210 (D) mm  
Weight:  
Below measurable limits  
Radio  
Approx. 1.12 kg (not including batteries)  
Reception frequency:  
FM: 87.5 - 108 MHz  
AM: 526.5 - 1606.5 KHz  
Specifications subject to change without no-  
tice.  
 
5

Radio Shack Clock 63 117 User Guide
Radio Shack Door 63 984 User Guide
RCA Network Hardware ANT700R User Guide
Rikaline GPS Receiver E 705 User Guide
Samsung Air Conditioner SC12ZB1 User Guide
Samsung Graphics Tablet GT P7500 User Guide
Sanyo Camera Lens LNS T31A User Guide
Sanyo Projector PLV Z3 User Guide
Sears Pressure Washer 58075151 User Guide
Senco Air Compressor PC2016 User Guide