Russound Door DIM 1 User Guide

DIM-1  
Instruction Manual  
Doorbell Interface Module  
DOORBELL INTERFACE  
POWER  
+12VDC  
TRIG  
 
switched contacts at the doorbell chime module to the connections  
labeled “DB1,” “DB2” and “DB3” on the DIM-1. This connects up to 3  
separate doorbell buttons to the DIM-1. Refer to Figure 1. Note that the  
connectors can be unplugged for easy wiring.  
4) Connection to Multi-zone System: The trigger  
DOORBELL INTERFACE  
POWER  
output of the DIM-1 connects to the audio  
system using a 1/8" mono plug. Connect the  
+12V DC  
mono plug to the controller (see below for  
TRIG  
specific system connections) and snip off the  
excess length from the other end of the cable.  
Strip the two wires from this end and  
Figure 2  
determine which wire comes from the tip by  
using a continuity meter. The wire from the  
tip (+) connects to the "TRIG OUT (+)"  
terminal of the DIM-1. The other wire from the  
sleeve (-) connects to the "TRIG OUT (-)" of  
the DIM-1. Refer to Figure 2.  
(-) Sleeve  
(+) Tip  
4a) PR-4Zi Connection: For operation with the PR-4Zi, connect the 1/8” mini  
plug into the Mute Input connection. Refer to Figure 3.  
4b) CAi Series Connection: For operation with the CA4.4i/CA6.4i, connect the  
1/8” mini plug into the Mute Input connection. Refer to Figure 4.  
4c) CAV Series Connection: For operation with the CAV6.6, connect the 1/8”  
mini plug into the Page Trigger Input connection. Refer to Figure 5.  
DOORBELL INTERFACE  
DOORBELL INTERFACE  
DOORBELL INTERFACE  
POWER  
POWER  
POWER  
+12V DC  
+12V DC  
+12V DC  
TRIG  
TRIG  
TRIG  
Figure 5  
Figure 3  
Figure 4  
(-) Sleeve  
(+) Tip  
(-) Sleeve  
(+) Tip  
(-) Sleeve  
(+) Tip  
MUTE  
OUT  
IN  
PR-4Zi  
CAi Series  
CAV6.6  
 
Operating Instructions  
1) Power the doorbell system and your audio distribution system.  
2) Plug the 12VDC power supply into the DIM-1. The red and green LED  
should be on. After 6 seconds the green LED will go out.  
3) Ring the doorbell. The green LED on the DIM-1 should illuminate for 6  
seconds and then go out.  
4) Play audio through the audio system.  
5) Ring the doorbell while the audio is playing. The audio should mute for 6  
seconds and then return.  
Limited Warranty  
The Russound DIM-1 is fully guaranteed against all defects in materials and workmanship for  
two (2) years from the date of purchase. During this period, Russound will replace any defec-  
tive parts and correct any defect in workmanship without charge for either parts or labor.  
For this warranty to apply, the unit must be installed and used according to its written instruc-  
tions. If service is necessary, it must be performed by Russound. The unit must be returned to  
Russound at the owner's expense and with prior written permission. Accidental damage and  
shipping damage are not considered defects, nor is damage resulting from abuse or from ser-  
vicing by an agency or person not specifically authorized in writing by Russound. This  
Warranty does not cover: Damage caused by abuse, accident, misuse, negligence, or improp-  
er installation or operation; Power surges and lightning strikes; Normal wear and mainte-  
nance; Products that have been altered or modified; Any product whose identifying number,  
decal, serial number, etc. has been altered, defaced or removed. Russound sells products only  
through authorized Dealers and Distributors to ensure that customers obtain proper support  
and service. Any Russound product purchased from an unauthorized dealer or other source,  
including retailers, mail order sellers and online sellers will not be honored or serviced under  
existing Russound warranty policy. Any sale of products by an unauthorized source or other  
manner not authorized by Russound shall void the warranty on the applicable product.  
Damage to or destruction of components due to application of excessive power voids the  
warranty on those parts. In these cases, repairs will be made on the basis or the retail value of  
the parts and labor. To return for repairs, the unit must be shipped to Russound at the owner's  
expense, along with a note explaining the nature of service required. Be sure to pack the unit  
in a corrugated container with at least three (3) inches of resilient material to protect the unit  
from damage in transit. Before returning a unit for repair, call Russound at (603) 659-5170 for  
a Return Authorization number. Write this number on the shipping label and ship to:  
Russound, ATTN: Service,5 Forbes Road, Newmarket, NH 03857  
5 Forbes Rd. Newmarket, NH 03857, USA  
603.659.5170 • Fax 603.659.5388  
Rev. 1 28-1102  
 

QSC Audio Speaker AD S52T User Guide
Rolls MP3 Docking Station RA62C User Guide
Samsung Blu ray Player BD D5500 User Guide
Samsung Laptop Q71 User Guide
Samsung TV Receiver SBB NT User Guide
Sanyo Camcorder VCB 3572IRP User Guide
Sanyo Cell Phone SCP 7050 User Guide
Seagate Computer Drive 5400 RPM User Guide
Seiko Instruments Marine GPS System LP 1020 User Guide
Sennheiser Headphones DW Pro1 HS User Guide